Contact a Galati Yacht Sales Professional Specialist For More Information On this Yacht
This Superlative Yacht Has Many Custom Details And Is Indisputably, A CUSTOM BUILT Work Of Art. Having Sleeping Quarters For Six, And A Creative, Spacious Interior, A Hull Shape She Shares Its Heritage With Deep V Hulls, Yielding A Smooth Ride In Rough Seas, Along With Rolls Royce Jet Drive Propulsion System Allowing Shallow Water Access, She Travels In Shallow Spots Many 50 Plus Foot Vessels Dare Not.
Yet There Is So Much More. Her Aft Cabin, With Queen Sized Bed, Has An Enormous Cockpit Aft Of It. Few Yachts Can Claim Both A Large Cockpit AND A Large Aft Cabin With Centerline Bed. More, She has A Full Sized STAND UP Sub Zero Refrigerator With Two Freezer Drawers Beneath In Her Galley, A Real Pump Room, An Engine Space With Large Doors Providing Excellent Access, Great Engine Room Headroom For Tall Individuals, A Flying Bridge With Excellent Seating And View Of The Deck, A Fordeck Anchor Tray Of Artistic Quality, And More. These Are Just Some Of The Many Features She Possesses.
They Are Characteristics Costing A Lot, And Not Seen Due To Expense Versus Logic...
SACHUEST Was Built At A Cost Of Nearly $3,000,000, In 2007. The Details And Special Nature Of Her Build Are Obvious To Those Who Look Deeply.
This Yacht Would Make A Superb Platform For A Family Cruise To The Caribbean Or Mediterranean Or Florida Keys, Jersey Shore, Cape Cod, Maine, Chesapeake, Bahamas. A European Destination Is Not Out Of The Realm Of Possibilities.
She Is Fully Equipped. She Is Superb And We Hope You Will Put Her On Your List.
With Less Than 300 Total Engine Hours, She Has Had Recent MAN Engine Service, Full Rolls Royce Water Jet Service.
Please Don't Miss Purchasing This American Built Superstar.
Galati Yacht Sales is pleased to assist you in the purchase of this vessel. This boat is centrally listed by Davidson Yachts.
Raised salon motoryacht with bridge deck and aft cabin and cockpit. Sleeping accommodations for eight with master cabin aft, four bunks forward and two in the salon. Galley is down. This layout works well for a family with children and/or grandchildren.
The forward end of the vessel is spacious and open with four over/under berths. The top berths fold down to make the lowers into settees with storage behind. There is a drop-leaf table on centerline.
The galley is aft to port, and there is a head and stall shower to starboard. The machinery compartment can be accessed from behind the stairs (power lift) to the salon.
The salon has a steering station to starboard with a utility desk to port. A high/low TV lifts out of this desk. There is storage for charts and books within.There is port and starboard access to the deck for easy docking. The dinette is aft to port with a settee to starboard. The dinette lowers to make another double berth. Access to the boat deck is aft, behind the settee and to starboard of the stairs to the aft cabin.
The master cabin has a walk-around off-center king berth, a writing desk, ensuite head and stall shower.
There is access to the cockpit aft to port. The machinery room is accessed from the master cabin through a door forward to starboard. The berth has a custom multi-layer memory foam mattress. There are 23 drawers, two hanging lockers and one wet locker in this cabin.
The engine room is located aft under the cockpit and is accessed through multiple hatches from the cockpit.
The interior is finished in satin varnished teak. The sole is solid teak with satin finish and wenge inlay. The counter tops are Corian. Upholstery is Jade UltraSuede above and Tea Rose UltraSuede below.
OceanAire window shades in main salon
Ocean Aire hatch shades and screens (3)
Custom king-sized mattress in owner’s cabin
Hood stainless steel opening ports throughout
To complete the thinking surrounding Sachuests' superb nature, the galley was conceived with comfort and convenience to the chef, and access to the childrens's cabin, along with ventilation and lighting. There are numerous opening ports in this area and the galley benefits from an open area connection to the salon, yielding a very high ceiling.
Sub Zero Model 700 ICI-3 combination refrigerator/freezer/icemaker, large refrigerator above with two drawer freezers below
Miele electric oven with Gaggenau four-burner propane cooktop
Sanyo microwave-may operate from inverter power
Stainless steel double sinks
Sandstone Corian counter tops
Numerous storage lockers and large trash canHEADS
MacKenzie Childs hand-painted wash bowls
Full-sized shower with seat in both heads
Heated towel bars in both
Head Hunter high pressure vacuum heads
Seacock for head discharge with key switches at helm to satisfy USCG requirements
The initial bottom layer of planking consists of ¾” T & G Silver Bali laid horizontally over the station molds. The next layers were three 9 mm Okumbe marine grade plywood layers of planking; the first laid 45 degrees to the keel (aft to forward), the second laid 45 degrees to the keel (forward to aft) and the third laid horizontally. Each layer was separately vacuum bagged. The topside used the same construction method, but for reasons of controlling weight, one of the 9mm layers of plywood was replaced with a 1” layer of Corecell foam. The outside layer of the hull was covered with a 24 oz. woven
roving cloth, and a 5’ strip of Kevlar cloth was overlaid down the length of the keel for strength. Hull is Awlgripped Sachuest Grey.
The upper house and bridge were constructed of Nydacore and structural fiberglass. Most of the curved surfaces on the bridge face, boat deck and transom seat were Nydacore, with the back side scarfed, curved and epoxied to maintain the shapes. All Nydacore edges were routed and dressed with solid structural fiberglass.
Nick Jackson 1,000 lb. capacity electric crane on boat deck serving tender
Caribe 11.5 foot tender with three-point lifting straps
Yamaha 15 hp outboard engine
Maxwell anchor windlass, Model 3500
Maxwell automatic chain counter, Model 500 C, at upper and lower helms
250 ft. galvanized anchor chain
60 lb. Suncor stainless steel Plowmaster anchor
Fortress secondary anchor with 300’ braided rode
Custom stainless steel anchor tray and rollers (self-draining)
Fresh and salt water anchor washdown system fore and aft
Exalto wiper control system with variable speed and wash down features
The yacht was developed with a 24VDC electrical system, which in turn supports a 48 VDC bow thruster and several 12 VDC navigation systems. The HVAC system, refrigerator and electric oven require 110 VAC service and the washer/dryer utilize 220 VAC. There are several battery chargers as part of the overall electrical system: the main battery charger serves the house batteries. A separate charger is dedicated to the engine cranking batteries. In addition to fore and aft shore power connections, the vessel has a 5000 watt Mastervolt inverter that converts DC current into AC power. Additionally, there are two DC-to-DC transformers that reduce 24 VDC to 12 VDC which is required to power the navigation systems and one DC-to-DC step up transformer that increases 24VDC power to 48 VDC to power the electric variable-speed Westmar bow thruster.
Each engine has two alternators; a small alternator that produces DC power that goes directly to the engine cranking batteries, each engine has its own Lifeline AGM battery, and a large 170 AMP alternator that supplies DC power to the house batteries.
The eight 8-D house batteries, GPL 8's DL, in turn supply power to the bow thruster batteries and the navigation back-up battery by means of DC-to-DC transformers and/or converters. A separate generator charger is dedicated to the Genset and controlled by a breaker switch in the center right AC breaker panel labeled Genset charger. There are also four bow thruster batteries devoted solely to
Head Hunter Tank Sentry gauges and monitors for fuel, potable water, grey water and waste water
Striker spotlight with remote control
Bow and stern power connections with Cablemaster reel aft
(2) 25’ 50 amp shore power cables for fore and aft connections
FurunoNav Net BB VX2 central navigation center, controlling:
Furuno plotter/radar Model 1834C w/4 KW closed array radar antenna
Furuno plotter/radar Model 1954C w/12 KW open array radar antenna
Operating software upgraded to C-MAP 3.04 Version installed in BB (7-21-2009)
ICOM Model IC M 604 VHF radios (2) with mikes at upper and lower helms
AIRMAR Weather Station sensor antenna
Furuno Model RD 30 displays (3) (upper and lower helms and aft stateroom)
Autopilot – Simrad Model AP-50 duel station
Satellite television antenna dish, Seatel Coastal Model 18
Alpine stereo system with speakers in all cabins, cockpit and bridge
Samsung flat screen TV in salon on custom lift
NOW SHOWING RESULTS - OF